#Salto ilocker install#

No modification of any kind, other than those described in these instructions, is permitted. The safety features of this product are essential to its compliance with EN 179. If the lockset is used in a harsh environment, lubrication should be applied more frequently. This can prolong the life o the lockset by reducing excessive wear. We recommend, however, continued periodic lubrication of moving parts like, latch, auxiliary latch and deadbolt, with commercial quality grease (every 20.000 cycles or once a year). MaintenanceДЄll locks come from the factory pre-lubricated with grease.

#Salto ilocker install#

For the auxiliary latch to operate correctly, it is absolutely essential to install the dust box.Strike flap should protrude at least 2mm, if it does not, please ask your distributor for the availability of special strikes.ДЇor models with detectors, connect according to the corresponding electronic escutcheon installation guide.Gap between door and jamb is between 2-4 mm.Deadbolt and latch fit the cavities of the strike without touching it.Place dust box and strike and fasten with the supplied screws. Using strike as template, mark and chisel recess.Refer to latch to determine strike location on jamb.Fasten with faceplate screws to hold lock in place. Please use the template in the escutcheon box. NOTE: Holes for fixation of SALTO electronic escutcheon are not included in this template. Draw the outline using the face plate as template for door preparation. Make door preparation of the lockcase according to (A). Mark only top and bottom holes of mortise cavity (A) and lock front (B) on door edge, and holes in the lateral face of the door for handles (C) and cylinder (D) (only needed in inside face). Position templates on edge and sides of door.Draw a vertical line on each side of the door at the proper backset to align the template.Draw a vertical centre line on door edge.Draw a horizontal line on both sides and edge of the door at the desired height of handle above floor.